Hi,
My question is on the diagram of Palo Alto firewall.
As explained in the video , that we create sub interface on e1/1 for inside ,outside and dmz.
I was not able to do the same on Eve-ng as 1 interface could only be mapped once.
Kindly help me understand if I missed on something or this will not work in EVE-ng environment
Warm Regards
raj
Hello
It might be the EVE-NG limitation. But don’t worry about that - you can use any other interface you want. Physical interfaces will be fine, too. The interface type won’t affect your configuration.
Regards
Piotr
I know this is an old thread but I just watched the palo videos myself. You are correct in the mapping. If you look at the video, it would be impossible to connect up the devices from the network diagram. It appears that he should have made layer 3 interfaces but each with a subinterface:
Eth1/1.22(or whatever vlan its associated too)
Eth1/2.57
Eth1/3.87
Instead he did them all on the same interface eth1/1 with subinterfaces for every zone. Unless someone else can explain 